The name Grilon stands for a wide assortment of products available with different basic polyamides and modified with additives and fillers. This allows us to satisfy a wide spectrum of customer requirements.
Along with the range of basic products, grades with high impact strength, high stiffness, flame retardancy, electrical conductivity, etc. are available. We also offer variety of products for processing according to current process technologies such as injection moulding, extrusion, injection blow moulding, etc.
Grilon TS V0 is an unreinforced, normal vis-cosity, self-extinguishing Polyamid 66 + Polyamide 6 injection moulding grade.
Grilon TSG-30 is a heat stabilised, normal viscosity PA66 + PA6 injection moulding grade with 30% glass fibres. Grilon TSG-30 characterises itself through the following properties: Very good flow properties, exceptional surface finish, very easy processing.
Grilon TSS/4 LF 20 is a heat stabilised, normal viscosity PA66 and PA6 injection moulding grade with 20% lubricant (PTFE & Silicon).
Grilon TSS/4 LF 20 characterises itself through the following properties: exceptional bearing properties, low abrasion.
Grilon TSM-30 is a heat stabilised, normal viscosity PA66 + PA6 injection moulding grade with 30% mineral. Grilon TSM-30 characterises itself through the following properties: Very good flow behaviour, exceptional surface finish, low distortion, very easy processing.
Grilon TSS/4 is an unreinforced, heat stabilised, normal viscosity PA66 + PA6 injection moulding grade. Grilon TSS/4 characterises itself through the following properties : Very good flow behaviour, easy to process, short cycle times.
Nylon 6.6/6.10film grade resin with good barrier properties:
Grilon BM 20 SBG
Grilon BM 13 SBG
Grilon BM 17 SBG
isFDARegulations CFR21 paragraph 177.1500 (Direct contact) listed for direct contact with foodstuff.
